Mitsubishi Outlander: Manual mode
The manual adjustment mode is also available in case the “Auto mode” shows the
incorrect time when the adjacent local RDS stations are located in a different time
zone.
For manual time adjustment, use the procedure below:
1. Switch off the audio once by pressing the PWR switch (1).
2. While pressing
the CH4 button (2), press the PWR switch (1) until it beeps. The “CT” display (A)
disappears and this is the “Manual adjustment mode”.
3. Set the time by pressing
the various buttons as described below.
H - To adjust the hour
M - To adjust the minutes
SET- To reset the minutes
to zero
10:30 - 11:29 ... Changes to 11:00
11:30 - 12:29 ... Changes to 12:00
READ NEXT:
For vehicles with a MITSUBISHI genuine audio, average fuel consumption, driving
range and average speed can be displayed besides average fuel consumption by pushing
the “DISP” button in the au
Every time the “DISP” button is pressed lightly (less than 2 seconds), the display
can be changed.
Average fuel consumption Driving range Average speed
This value shows the average fuel consumption (in L/100 km or mpg) since the
display was reset. If you reset the display at the time when you want to start the
measurements, average fuel consump
SEE MORE:
The storage location of the tools and jack should be remembered in case of an
emergency.
Location
1- Tools 2- Jack
Tools
1- Tool bag 2- Wheel nut wrench 3- Bar
Jack
1- To remove
Turn the shaft end so that the jack retracts and detach it from fixing bracket
(A).
2- To store
Turn th
The electronically controlled 4WD system is a 4- wheel drive system that allows
one of three drive modes to be selected with a dial, in accordance with the driving
conditions.
The following drive modes are available.
4-wheel drive operation requires special driving skills.
Carefully read th
© 2010-2026 Copyright www.mioutlander.com
