Mitsubishi Outlander: Digital clock

Following modes are available for clock adjustment: MITSUBISHI genuine audio:
- “Auto mode” and “Manual mode”
- Non genuine audio: “Manual mode” only
Selection of “Auto mode” or “Manual mode” (MITSUBISHI genuine audio only)
1. Switch off the audio once by pressing the PWR switch (1).
2. While pressing the CH4 button (2), press the PWR switch (1) until it beeps.
“CT” displayed: Auto mode
“CT” not displayed: Manual mode
For manual time adjustment, please refer to “Manual mode” below.
READ NEXT:
(MITSUBISHI genuine audio only)
The automatic adjustment mode can set the local time automatically by using the
signal from the local RDS stations. In this mode, “CT” (A) (Clock Time: sent with
The manual adjustment mode is also available in case the “Auto mode” shows the
incorrect time when the adjacent local RDS stations are located in a different time
zone.
For manual time adjust
For vehicles with a MITSUBISHI genuine audio, average fuel consumption, driving
range and average speed can be displayed besides average fuel consumption by pushing
the “DISP” button in the au
SEE MORE:
If a hand or head is trapped in the closing sunroof, it will reopen automatically.
Nonetheless, make sure that nobody puts their head or hand out of the sunroof
when opening or closing.
The opened sunroof will become operational after a few seconds.
If the safety mechanism should be activated 5
This indication lamp illuminates when the ignition switch is placed in the “ON”
position. As the glow plug becomes hot, the lamp goes out and the engine can be
started.
Note
► If the engine is cold, the diesel preheat indication lamp is on for a longer
time.
► When the en
© 2010-2025 Copyright www.mioutlander.com
