Mitsubishi Outlander: Average speed
Mitsubishi Carisma / Mitsubishi Carisma Owner's Manual / Instruments and controls / Digital clock / Average speed
For vehicles with MITSUBISHI genuine audio, average speed can be displayed. This value shows the average speed (in km/h or mph) since the display was reset. If you reset the display at the time when you want to start the measurements, average speed from that point of time can be displayed.
To reset the display, push the “DISP” button for about 2 seconds or more.
READ NEXT:
Display brightness adjustment / Display unit selection
Display brightness adjustment
1. Press the “H” button while pressing the button (A) to activate the display
brightness selection function.
2. Adjust the brightness by moving the cursor with
Display unit selection
Originally, km/h and L/100 km are selected. When you want to select the unit
“mile”, follow this procedure.
NOTE
For vehicles without MITSUBISHI genuine audio system, only the unit of averag
SEE MORE:
ACD control mode switch
When the ignition switch is set to the “ON” position, operate the AWC switch
to change the control mode.
Each time the switch is pushed, the control mode changes in the order “TARMAC”
→ “GRAVEL” → “SNOW” → “TARMAC”.
Note
► The control mode can be
LW/MW/FM digital tuning radio with CD player
The audio system can only be used when the ignition switch is in the “ON” or
“ACC” position.
Note
► When listening to the audio system while the engine is not running, be sure
to turn the ignition switch to the “ACC” position.
If the ignition switch is left in the “ACC”
© 2010-2025 Copyright www.mioutlander.com
