Mitsubishi Outlander: [With a CD autochanger]
1. Press the CD button (3), and the CD autochanger mode will be selected, starting a playback. Each time the CD button is pressed, one in the autochanger is played back alternately.
NOTE
To listen to another disc in the CD autochanger, press the DISC button (6),
to select the disc. Every time the 
side of the DISC button is pressed, the next disc is selected. Every time the
side of the button is pressed, changeover
to the previous disc is made.
2. To adjust the volume and tone, refer to the section “How to adjust the volume”
and “How to adjust the tone” on page 6–17.
3. To stop the CD, turn off the power
by pressing the PWR switch (1) or make changeover to the other mode by pressing
the U/M/L button (2).
4. For information concerning the handling of compact discs,
refer to the section “Handling of compact discs” on page 6–27.
READ NEXT:
To find the start of a desired track
The start of each track on a disc can be found by using the
or
button (7 or 8).
Track up:
Press the button (8) the number
of tracks to skip over.
The frequency-display window will display th
How to repeat the same track
You can repeatedly listen to the same track by pressing the RPT button (10).
Press the RPT button, and the RPT indicator (15) will come on.
To release, press the button again.
How to use the SCAN b
Audio system anti-theft feature
To prevent theft of the audio system, the control panel can be removed. Always
remove the control panel when you leave the vehicle.
Removing the control panel
Turn the ignition switch to the OFF
SEE MORE:
Tether anchorage locations
There are 2 child restraint anchorage points located on the back of the seatbacks.
These are for fastening the child restraint tether straps to the 2 rear seat seating
positions.
Warning
► Child restraint anchorages are designed to withstand only those loads imposed
by correctly fit
Modification/alterations to the electrical or fuel systems
MITSUBISHI MOTORS CORPORATION has always manufactured safe, high quality vehicles.
In order to maintain this safety and quality, it is important that any accessory
that is to be fitted, or any modifications carried out which involve the electrical
or fuel systems, should be carried out in acco
