Mitsubishi Outlander: Auto stop
1. Stop the vehicle.
2. Place the gearshift lever in the “N” (Neutral) position.
3. Release the clutch pedal.
4. The “ ” display/indicator will turn on and the engine will stop automatically.
READ NEXT:
Auto go
Depress the clutch pedal while the gearshift lever is in the “N” (Neutral) position.
The “ ” display/indicator turns off and the engine restarts automatically.
System characteristics
The principle of the Auto Stop & Go (AS&G) system is that it adapts to the vehicle’s
needs (i.e. energy supply). This means that in certain circumstances the engine
will not stop and in
SEE MORE:
Licence plate lamps
1. Remove while pressing the lamp unit (A) to the left side.
2. Insert a minus screwdriver with the end covered with a cloth or other object
to press the hook (B) aside and remove the lens.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal steps in reverse.
Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
: Front of the vehicle
3. Turn the bulb (C) antic
© 2010-2025 Copyright www.mioutlander.com
