Mitsubishi Outlander: To operate
To operate the system, move the gearshift lever or selector lever to the “R” position while the ignition switch is in the “ON” position. When the reversing sensor system is operated, the reversing sensor system operation indication lamp (A) will turn on. To stop the operation, push the “SONAR” switch; the reversing sensor system operation indication lamp (A) is turned off.
Note
► Only when the gearshift lever or selector lever is in the “R” position, the reversing sensor system can be operated or be stopped by using the “SONAR” switch.
READ NEXT:
Warning for obstacles
If there is an obstacle behind the vehicle, a warning will be issued with the
information screen in the multi-information display and a warning buzzer.
1- Corner sensor (left)
2- Back sensor
3-
Changing the detection areas
The detection areas can be changed as follows:
Vehicles with a towing bar
While the operation of the system is stopped at the “SONAR” switch, push the
“SONAR” switch approximately 3 second
Reversing sensor system warning display
In case there is a malfunction in the reversing sensor system, the display for
the malfunctioning sensor will blink and the warning buzzer will sound for approximately
5 seconds. Even after the bu
SEE MORE:
Accessory socket
CAUTION:
● Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W or
less.
When using more than one socket at the same time, make sure that the electrical
accessories are 12 V accessories and that the total power consumption does not exceed
120 W.
● Long us
Emergency starting
If the engine cannot be started because the battery is weak or dead, the battery
from another vehicle can be used with jumper cables to start the engine.
WARNING
• To start the engine using jumper cables connected to another vehicle, perform
the correct procedures according to the instructi
© 2010-2025 Copyright www.mioutlander.com
