Mitsubishi Outlander: Changing the detection areas
The detection areas can be changed as follows:
Vehicles with a towing bar
While the operation of the system is stopped at the “SONAR” switch, push the “SONAR” switch approximately 3 seconds or more, and release it. The buzzer sounds twice to indicate that the detection area has been changed.
Vehicles without a towing bar
While the operation of the system is stopped at the “SONAR” switch, push the “SONAR” switch approximately 3 seconds or more, and release it. The buzzer sounds once to indicate that the detection area has been changed.
Note
► The detection area will not change if you keep the “SONAR” switch pushed for
10 seconds or more.
► After pushing the “SONAR” switch, reversing sensor system operation differs according
to the detection area setting.
• Setting when towing bar is not equipped When the gearshift lever or selector lever is moved to the “R” position, the reversing sensor system will operate even if corner sensor operation was stopped by pushing the “SONAR” switch.
• Setting when towing bar is equipped When reversing sensor system operation was stopped by pushing the “SONAR” switch, the reversing sensor system will not operate until the engine has been stopped even if the gearshift lever or selector lever is moved to the “R” position.
To resume reversing sensor system operation, push the “SONAR” switch or stop and restart the engine, and then move the gearshift lever or selector lever to the “R” position.
READ NEXT:
Reversing sensor system warning display
In case there is a malfunction in the reversing sensor system, the display for
the malfunctioning sensor will blink and the warning buzzer will sound for approximately
5 seconds. Even after the bu
Rear-view camera
The rear-view camera is a system that shows the view behind the vehicle on a
screen of the MITSUBISHI Multi Communication System (MMCS) or the inside rear-view
mirror.
Caution
► The rear-
Range of view of rear-view camera
The range of view of the rear-view camera is limited to the area shown in the
illustrations. It cannot show both sides and the lower part of the rear bumper,
etc.
When reversing, be sure to visua
SEE MORE:
To listen to a CD
1- PWR (On-off switch) 2- U/M/L button 3- CD (CD mode changeover) button
4- Disc loading slot 5- CD eject button 6- DISC (Disc selection) button* 7-
(Track down) button 8- (Track up) button 9- SCAN button 10- RPT (Repeat) button
11- RDM (Random) button 12- DISC indicator* 13- CD indicator 14
To lock or unlock with the key
1- Lock
2- Unlock
Note
► On vehicles equipped with the central door lock switch, when locking or unlocking
with the key, only the driver’s door will be locked or unlocked.
To lock or unlock all doors and the rear hatch, use the central door lock switch,
the keyless entry system or
