Mitsubishi Outlander: Warning for obstacles
If there is an obstacle behind the vehicle, a warning will be issued with the information screen in the multi-information display and a warning buzzer.
1- Corner sensor (left)
2- Back sensor
3- Corner sensor (right)
Corner sensor
Back sensor (vehicles without a towing bar)
Back sensor (vehicles with a towing bar)
Caution
► The distances given are to be used for reference only, as errors may be caused by various factors, such as temperature, humidity, or the shape of the obstacles.
Note
► When the sensors detect different obstacles at the same time, the information
screen in the multi-information display indicates the directions of the obstacles
each sensor is detecting.
However, closer obstacles are given priority over other detected obstacles and the
warning buzzer sounds to inform you of closer obstacles.
READ NEXT:
Changing the detection areas
The detection areas can be changed as follows:
Vehicles with a towing bar
While the operation of the system is stopped at the “SONAR” switch, push the
“SONAR” switch approximately 3 second
Reversing sensor system warning display
In case there is a malfunction in the reversing sensor system, the display for
the malfunctioning sensor will blink and the warning buzzer will sound for approximately
5 seconds. Even after the bu
Rear-view camera
The rear-view camera is a system that shows the view behind the vehicle on a
screen of the MITSUBISHI Multi Communication System (MMCS) or the inside rear-view
mirror.
Caution
► The rear-
SEE MORE:
Fuse load capacity
The fuse capacity and the name of the electrical systems protected by the fuses
are indicated on the inside of the coin box located at the driver’s leg area and
on the fuse box lid for fuses located in the engine compartment.
Passenger compartment
NOTE
Spare fuses are contained in the fus
Operation of the automatic transmission INVECS-II
CAUTION
(1) Before selecting a gear with the engine running and the vehicle stationary,
fully depress the brake pedal to prevent the vehicle from creeping. The vehicle
will begin to move as soon as the gear is engaged, especially when the engine speed
is high, at fast idle or with the air con
