Mitsubishi Outlander: Child restraint system with ISOFIX mountings
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Seat and seat belts / Child restraint / Installing a child restraint system to the lower anchorage (ISOFIX child restraint
mountings) and tether anchorage / Child restraint system with ISOFIX mountings
The child restraint system is designed only for seats that incorporate lower anchorages. Retain the child restraint system using the lower anchorages.
It is not necessary to retain the child restraint system using the vehicle’s seat belts.
A- Child restraint system connectors
READ NEXT:
To install
1. Remove any foreign material in or around the connectors and ensure the vehicle
seat belt is in its normal storage position.
2. Push the child restraint system’s connectors (A) into the slit (B
To remove
Remove the child restraint in accordance with the instructions provided by the
child restraint system’s manufacturer.
Installing a child restraint system to a 3-point type seat belt (with emergency
locking mechanism)
Installation:
1. Fasten the seat belt to secure the child restraint system. Make sure you hear
a “click” when you insert the latch plate in the buckle.
2. Remove all slack by using the locki
SEE MORE:
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “LOCK”, wait a few seconds, and then try again.
Trying repeatedly with the starter motor still turning will damag
Procedure for replacing the remote control switch battery
1. Remove the screw (A) from the remote control switch.
2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight
blade (or minus) screwdriver into the notch in the remote control switch case and
use it to open the case.
NOTE
• Be sure to perform the procedure
© 2010-2025 Copyright www.mioutlander.com
