Mitsubishi Outlander: Corner and back sensor locations
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Reversing sensor system / Obstacle detection areas / Corner and back sensor locations
There are two corner sensors (A) at the corners of the rear bumper, and two back sensors (B) in the centre of the rear bumper.
READ NEXT:
Reversing sensor system detection areas
Depending on whether the vehicle is equipped with a towing bar, you can change
the reversing sensor system between the standard mode and the towing bar mode. The
towing bar mode changes the system
To operate
To operate the system, move the gearshift lever or selector lever to the “R”
position while the ignition switch is in the “ON” position. When the reversing sensor
system is operated, the r
Warning for obstacles
If there is an obstacle behind the vehicle, a warning will be issued with the
information screen in the multi-information display and a warning buzzer.
1- Corner sensor (left)
2- Back sensor
3-
SEE MORE:
Rear room lamp
The room lamp can be turned on by sliding the room lamp switch.
1 (ON) - The room lamp goes on.
2 ( ) - The lamp illuminates when a door or the rear hatch is opened. It goes
off about 15 seconds after the door or rear hatch is closed.
However, the lamp goes off immediately in the following ca
Power type (driver’s side only)
Adjust the seat by operating the switch as indicated by the arrows.
1- Adjustment forward
2- Adjustment backward
Note
► To prevent the battery from running down, operate the power type seat with
the engine running.
© 2010-2026 Copyright www.mioutlander.com
