Mitsubishi Outlander: Dipper (High/Low beam change)
Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Instruments and controls / Combination headlamps and dipper switch / Dipper (High/Low beam change)
When the lamp switch is in the 
position,
the beam changes from high to low (or low to high) each time the lever is pulled
fully (1). While the high beam is on, the high-beam indication lamp in the instrument
cluster will also illuminate.
READ NEXT:
Headlamp flasher
The high-beams flash when the lever is pulled slightly (2), and will go off when
it is released.
When the high-beam is on, the high-beam indication lamp in the instrument cluster
will illuminate.
Welcome light
This function turns on the position and tail lamps for about 30 seconds after
the UNLOCK switch (A) on the remote control transmitter is pressed when the combination
headlamps and dipper switch is
Coming home light
This function turns on the headlamps in the low beam setting for about 30 seconds
after the ignition switch is turned to the “OFF” position or the operation mode
is put in OFF.
1. Turn the co
SEE MORE:
Starting the engine (diesel-powered vehicles)
[For vehicles equipped with keyless operation system]
For information on operations for vehicles equipped with the keyless operation
system, refer to “Keyless operation system: Starting” on pages 1-17, 1-20.
[Except vehicles equipped with keyless operation system]
1. Insert the ignition key
To reduce the set speed
There are 2 ways to reduce the set speed.
Auto–speed control lever
Pull down and hold the auto–speed control lever until you reach the lower speed
you want. Release the lever when the desired speed is reached.
To slow down in small amounts, just pull down the auto–speed control lever fo
© 2010-2026 Copyright www.mioutlander.com
