Mitsubishi Outlander: Door ajar warning display screen (when the ignition switch is “OFF”)
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Door ajar warning display screen (when the ignition switch is “OFF”)
If any of the doors or the rear hatch is not completely closed, this displays the open door or rear hatch.
1- Doors and rear hatch are closed
2- Doors or rear hatch is open
READ NEXT:
Information screen (when the ignition switch is turned from “OFF” to “ON”)
When the ignition switch is turned to the “ON” position, the display screen switches
in the following order.
1- Screen when the ignition switch is “OFF”
2- System check screen
3- Screen
ACD (Active centre differential system) control mode display screen
The ACD operation status is displayed.
Refer to “ACD control mode switch”.
Mark display screen (when the ignition switch is “ON”)
This is displayed when you press the multi- information meter switch and switch
the warning display screen.
This mark is also displayed if there is another warning other than the one displayed.
SEE MORE:
Driver’s seat belt reminder/warning lamp and display
Warning lamp
A tone and warning lamp are used to remind the driver to fasten the seat belt.
If the ignition switch is set to the “ON” position without the driver’s seat
belt being fastened, a warning lamp will blink and a buzzer will sound for approximately
6 seconds to remind you to
Position lamps (for vehicles equipped with high intensity discharge headlamps)
1. To create enough work space, turn the steering wheel all the way in the direction
opposite to the side you wish to replace.
2. Remove the clips (A) and screws (B) to turn up the cover (C).
3. Turn the socket (D) anticlockwise to remove it.
4. Pull the bulb out of the socket.
5. To i
© 2010-2025 Copyright www.mioutlander.com
