Mitsubishi Outlander: Driving hints
(1) TCL does not actively apply brakes. Always decelerate the vehicle sufficiently
before entering corners or bends.
(2) On snowy or icy roads, drive slowly using
tyre chains or snow tyres.
(3) When the TCL indication lamp illuminates, SLIP
control is being operated, and it means that the road is slippery or your vehicle
is excessively accelerating. In this situation, release foot from the accelerator
pedal and maintain moderate speed.
(4) Never mix or use tyres of different size
since the TCL system could function incorrectly and make safe driving difficult.

READ NEXT:
1. When the ignition switch is turned “ON”, the TCL indication lamp illuminates
and goes out after a few seconds. 2. When SLIP control is exerted while driving,
the TCL indication lamp will il
Auto–speed control is an automatic speed control system to maintain a desired
driving speed of about 40 km/h or more without operating the accelerator pedal.
This feature is especially useful f
1. Push the main switch (A) at the end of the auto–speed control lever. 2.
Pull down the lever (B) while driving at the desired speed.
When the main switch (A) is ON, the “CRUISE” indicat
SEE MORE:
The electric power steering system (EPS) uses an electric motor to assist the
turning of the steering wheel.
Note
► During repeated full-lock turning of the steering wheel (for example, while
you are manoeuvring the vehicle into a parking space), a protection function may
be activated
Check the air pressure of the spare tyre frequently and make sure it is ready
for emergency use at any time.
Maintaining the spare wheel at the highest specified air pressure will ensure
that it can always be used under any conditions (city/high-speed driving, varying
load weight, etc.).
The
© 2010-2025 Copyright www.mioutlander.com
