Mitsubishi Outlander: To activate
1. Push the main switch (A) at the end of the auto–speed control lever.
2.
Pull down the lever (B) while driving at the desired speed.
When the main switch (A) is ON, the “CRUISE” indication lamp located in the instrument panel will illuminate.
CAUTION
(1) As a safety precaution, the main switch (A) should be set to “OFF”
position except when using the auto–speed control system.
(2) The use of the auto–speed
control is not recommended when driving conditions do not permit maintaining a constant
speed, such as heavy traffic or on roads that are winding, icy, snow–covered, wet,
slippery or a steep downhill grade.
(3) In the case of vehicles with a manual
transmission, if while driving at the set speed, the shift lever is set to the “N”
(Neutral) position without depressing the clutch pedal, the engine speed will increase
excessively, and the engine may be damaged.
NOTE
(1) When the ignition switch is switched OFF, the main switch will also automatically
switch off. If you wish to maintain a constant speed while driving, be sure the
main switch has been switched ON again.
(2) Note that the set vehicle speed may
not be maintained on uphill or downhill slopes.
(3) The vehicle speed may drop
to less than the set speed on a steep uphill grade, so the accelerator must be used
if you want to maintain that speed.
(4) The vehicle speed may increase to more
than the set speed on a steep downhill grade. When the vehicle speed increases excessively,
deactivate the auto–speed control. (Refer to ”To deactivate” on page 5–37.)
READ NEXT:
To increase the set speed
There are 2 ways to increase the set speed.
Auto–speed control le
Pull up the auto–speed control lever. And hold it until you reach the higer speed
you want. Release the lever when the desir
To reduce the set speed
There are 2 ways to reduce the set speed.
Auto–speed control lever
Pull down and hold the auto–speed control lever until you reach the lower speed
you want. Release the lever when the desire
To accelerate for passing
Depress the accelerator pedal in the normal way. When the pedal is released,
your vehicle will return to the set speed.
SEE MORE:
Emergency stop signal system
This is a device that reduces the possibility of rear end collisions by the rapid
and automatic blinking of the hazard warning lamps to alert vehicles approaching
from behind during sudden braking.
When the emergency stop signal system operates, the hazard warning indication
lamp in the instr
To deactivate
The auto–speed control can be deactivated by the following ways.
(1) Push the main switch at the end of the lever. (Main switch OFF) (2) Pull
the auto–speed control lever toward you.
The auto–speed control can be deactivated automatically in any of the following
ways.
(3) By slightly
