Mitsubishi Outlander: To increase the set speed

There are 2 ways to increase the set speed.
Auto–speed control le
Pull up the auto–speed control lever. And hold it until you reach the higer speed
you want. Release the lever when the desired speed is reached.
To increase your speed in small amounts, just pull up the auto–speed control
lever for less than 0.5 second and release it. Each time you operate the lever,
your vehicle will go about 2.0 km/h faster.

Accelerator
Use the accelerator pedal to increase the vehicle’s speed and, when the desired
speed is reached, pull down the auto–speed control lever.
READ NEXT:
There are 2 ways to reduce the set speed.
Auto–speed control lever
Pull down and hold the auto–speed control lever until you reach the lower speed
you want. Release the lever when the desire
Depress the accelerator pedal in the normal way. When the pedal is released,
your vehicle will return to the set speed.
The auto–speed control can be deactivated by the following ways.
(1) Push the main switch at the end of the lever. (Main switch OFF) (2) Pull
the auto–speed control lever toward you.
The aut
SEE MORE:
The audio system can only be used when the ignition switch is in the “ON” or
“ACC” position.
Note
► When listening to the audio system while the engine is not running, be sure
to turn the ignition switch to the “ACC” position.
If the ignition switch is left in the “ACC”
If any of the interior lamps are left switched on with the ignition switch in
any position other than “ON” or “ACC”, it goes off automatically after approximately
30 minutes.
The lamp goes on again if the ignition switch is turned to the “ON” or “ACC”
position, any door or the
© 2010-2025 Copyright www.mioutlander.com
