Mitsubishi Outlander: Indication lamp
1. When the ignition switch is turned “ON”, the TCL indication lamp illuminates
and goes out after a few seconds.
2. When SLIP control is exerted while driving,
the TCL indication lamp will illuminate.
CAUTION
(1) If the TCL indication lamp stays on or does not illuminate when the
ignition switch is turned ”ON”, it indicates that any malfunction may occur in the
system.
(2) If the TCL indication lamp flashes when you drive the vehicle, it
indicates that any malfunction occurs in the system. When either (1) or (2) happens,
have your vehicle checked at an authorized MITSUBISHI dealer.
READ NEXT:
Auto–speed control is an automatic speed control system to maintain a desired
driving speed of about 40 km/h or more without operating the accelerator pedal.
This feature is especially useful f
1. Push the main switch (A) at the end of the auto–speed control lever. 2.
Pull down the lever (B) while driving at the desired speed.
When the main switch (A) is ON, the “CRUISE” indicat
There are 2 ways to increase the set speed.
Auto–speed control le
Pull up the auto–speed control lever. And hold it until you reach the higer speed
you want. Release the lever when the desir
SEE MORE:
1. Before replacing a fuse, always turn off the electrical circuit concerned
and place the ignition switch in the “LOCK” position.
2. Remove the fuse puller (A) from the inside of the fuse box in the engine compartment.
3. Referring to the fuse load capacity table, check the fuse pertainin
You can make or receive hands-free calls using a Bluetooth® compatible cellular
phone connected to the Bluetooth® 2.0 interface.
You can also use the phone books in the Bluetooth ® 2.0 interface to make calls
without dialling telephone numbers.
To make a call
You can make a call in the fol
© 2010-2026 Copyright www.mioutlander.com
