Mitsubishi Outlander: Electronic immobilizer (Antitheft starting system)
[For vehicles equipped with keyless operation system] For information on operations for vehicles equipped with the keyless operation system, refer to “Keyless operation system: Electronic immobilizer (Anti-theft starting system)”.
[Except for vehicles equipped with keyless operation system] The electronic immobilizer is designed to significantly reduce the possibility of vehicle theft. The purpose of the system is to immobilize the vehicle if an invalid start is attempted. A valid start attempt can only be achieved by using a key “registered” to the immobilizer system.
Note
► In the following cases, the vehicle may not be able to receive the registered ID code from the registered key and the engine may not start.
• When the key contacts a key ring or other metallic or magnetic object (Type
A)
• When the key grip contacts metal of another key (Type B)
• When the key contacts or is close to other immobilizing keys (including keys of
other vehicles) (Type C)
In cases like these, remove the object or additional key from the vehicle key. Then try again to start the engine. If the engine does not start, we recommend you to contact your MITSUBISHI MOTORS Authorized Service Point.
► If you lose your key, contact your MITSUBISHI MOTORS Authorized Service Point as soon as possible.
To obtain a replacement or extra spare key, take your vehicle and all remaining keys to your MITSUBISHI MOTORS Authorized Service Point. All the keys have to be re-registered in the immobilizer computer unit.
The immobilizer can register up to 8 different keys.
Caution
► Don’t make any alterations or additions to the immobilizer system; alterations or additions could cause failure of the immobilizer.
READ NEXT:
Keyless entry system
Press the remote control switch, and all doors and the rear hatch will be locked
or unlocked as desired.
It is also possible to operate the outside rear-view mirrors.
1- LOCK switch
2- UNLOCK s
To lock
Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal
lamps will blink once.
Note
► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1
To unlock
Press the UNLOCK switch (2). All the doors and the rear hatch will be unlocked.
If the front room lamp switch (if so equipped) is in the “DOOR” position and the
rear room lamp switch (except f
SEE MORE:
To recline the seatback
Adjust the seatback angle by turning the dial.
1- To move to forward direction 2- To recline rearward
WARNING
To minimize the risk of personal injury in the event of a collision or
sudden braking, the seatbacks should always be in almost upright position while
the vehicle is in motion. The
Operation of the Twin Clutch SST
Caution
► Before selecting a position with the engine running and the vehicle stationary,
fully depress the brake pedal to prevent the vehicle from creeping.
The vehicle will begin to move as soon as the Twin Clutch SST is engaged, the brakes
should only be released when you are ready t
