Mitsubishi Outlander: Keyless entry system
Press the remote control switch, and all doors and the rear hatch will be locked or unlocked as desired.
It is also possible to operate the outside rear-view mirrors.
1- LOCK switch
2- UNLOCK switch
3- Indication lamp
- To lock
- To unlock
- Operation of the Dead Lock System
- Operation of the outside rear-view mirrors (Vehicles equipped with mirror retractor switch)
- Setting of door and rear hatch unlock function (vehicles equipped with the central door lock switch)
- Procedure for replacing the remote control switch battery
READ NEXT:
To lock
Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal
lamps will blink once.
Note
► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1
To unlock
Press the UNLOCK switch (2). All the doors and the rear hatch will be unlocked.
If the front room lamp switch (if so equipped) is in the “DOOR” position and the
rear room lamp switch (except f
Operation of the Dead Lock System
In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock
System using the remote controller. (Refer to “Dead Lock System”.)
SEE MORE:
Fuse load capacity
The fuse capacity and the name of the electrical systems protected by the fuses
are indicated on the inside of the coin box located at the driver’s leg area and
on the fuse box lid for fuses located in the engine compartment.
Passenger compartment
NOTE
Spare fuses are contained in the fus
Changing the detection areas
The detection areas can be changed as follows:
Vehicles with a towing bar
While the operation of the system is stopped at the “SONAR” switch, push the
“SONAR” switch approximately 3 seconds or more, and release it. The buzzer sounds
twice to indicate that the detection area has been ch
© 2010-2026 Copyright www.mioutlander.com
