Mitsubishi Outlander: Procedure for replacing the remote control switch battery
1. Before replacing the battery, remove static electricity from your body by
touching a metal grounded object.
2. Remove the screw (A) from the remote control switch.
3. With the MITSUBISHI mark facing you, insert the clothcovered tip of a straight blade (or minus) screwdriver into the notch in the remote control switch case and use it to open the case.
Note
► Be sure to perform the procedure with the MITSUBISHI mark facing you. If the MITSUBISHI mark is not facing you when you open the remote control switch case, the switches may come out.
4. Remove the remote control transmitter from the remote control switch case. Then, open the remote control transmitter using the method described in step 3.
5. Remove the old battery.
6. Install a new battery with the + side (B) down.
7. Close the remote control transmitter firmly.
8. Place the remote control transmitter in the remote control switch case, then
securely close the remote control switch case.
9. Attach the screw (A) removed in step 2.
10. Check the keyless entry system to see that it works.
Note
► You may purchase a replacement battery at an electric appliance store.
► A MITSUBISHI MOTORS Authorized Service Point can replace the battery for you
if you prefer.
Caution
► When the remote control switch case is opened, be careful to keep water, dust, etc. out. Also, do not touch the internal components.
READ NEXT:
Keyless operation system
The keyless operation system allows you to lock and unlock the doors and rear
hatch and start the engine simply by carrying the keyless operation key with you.
The keyless operation key can also be
Operating range of the keyless operation system
If you are carrying the keyless operation key, enter the operating range of the
keyless operation system, and operate a door or rear hatch switch, the ID code for
your key is verified.
You can on
Operating range for locking and unlocking the doors and rear hatch
The operating range is about 70 cm from the handle on the driver’s door, the
front passenger’s door, and rear hatch handle.
: Forward direction
: Operating range
Note
► Locking an
SEE MORE:
Starting the engine (diesel-powered vehicles)
1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal.
Note
► On vehicles with the Auto Stop & Go (AS&G) system, the starter will not operate
unless the clutch pedal is fully depressed (Clutch
Washer fluid
The windscreen washer fluid reservoir is in the engine compartment.
Check the washer fluid level at regular intervals and add washer fluid to reservoir
if necessary.
Open the reservoir cap and check the fluid level with the dipstick.
Note
► The washer fluid container serves the windsc
