Mitsubishi Outlander: Front turn–signal lamps
Mitsubishi Carisma / Mitsubishi Carisma Owner's Manual / For emergencies / Replacement of lamp bulbs / Front turn–signal lamps
Petrol–powered vehicles, Diesel–powered vehicles (right side)
Turn the bulb socket anticlockwise to remove. And remove the bulb from the socket by turning anticlockwise while pressing it inward.
Diesel–powered vehicles (left side)
1. Remove the cover.
2. Turn the bulb socket anticlockwise to remove it. And remove the bulb from the socket by turning anticlockwise while pressing it inward.
READ NEXT:
Side turn-signal lamps
Insert a straight blade (or minus) screwdriver at the edge of the lens, remove
the socket assembly and bulb together by turning it anticlockwise, and then remove
the bulb by pulling out.
NOTE
Front fog lamps
Remove the cover mounting screw.
Remove bolts (1) and (2) with a screwdriver, and pull the lamp body towards you.
NOTE
Do not turn the aiming adjusting bolt (3).
Remove the connector secured
Rear combination lamps
Hatchback
Remove the lid.
Turn the bulb socket anti-clockwise to remove it. And remove it anti-clockwise
while pressing it inward.
1- Tail lamp 2- Rear turn-signal lamp 3- Stop lamp
Sedan
T
SEE MORE:
Automatically stopping the engine
The Auto Stop & Go (AS&G) system is automatically activated when the ignition
switch is turned to the “ON” position. You can deactivate the system by pressing
the “Auto Stop & Go (AS&G) OFF” switch. Refer to “To deactivate”.
1. Stop the vehicle.
While depressing the
Average fuel consumption display
This displays the average fuel consumption from the last reset to the present
time.
There are the following 2 mode settings.
For information on how to change the average fuel consumption display setting,
refer to “Changing the function settings (when the ignition switch is “ON”)”.
T
© 2010-2025 Copyright www.mioutlander.com
