Mitsubishi Outlander: Hazard warning flasher switch
Use the hazard warning flasher switch when the vehicle has to be parked on the
road for any emergency.
The hazard warning flashers can always be operated, regardless of the position
of the ignition switch.
Push the switch to turn on the hazard warning flashers, all turn-signal lamps
flash continuously. To turn them off, push the switch again.

Note
► While the hazard warning lamps are blinking due to having manually pushed the
switch, the emergency stop signal system does not operate.
Refer to “Emergency stop signal system”.
READ NEXT:
The front fog lamps can be operated while the headlamps or tail lamps are on.
Turn the knob in the “ON” direction to turn on the front fog lamps. An indication
lamp in the instrument cluster w
The rear fog lamp can be operated when the headlamps or front fog lamps (if so
equipped) turn on.
An indication lamp in the instrument cluster comes on when the rear fog lamp
is turned on.
[Vehi
SEE MORE:
The heater and the air conditioning can be operated while the engine is running.
The performance of the heater is directly related to the temperature of the engine
coolant, so operate the heater after the engine has had a chance to warm up. The
amount of air flow can be regulated by adjustin
Type 1
Upper and lower boxes are located inside the floor console box.
The floor console box can also be used as an armrest.
1- Upper box
2- Lower box
To open the upper box, lift the right release lever (A) and raise the lid.
To open the lower box, lift the left release lever (B) and raise t
© 2010-2025 Copyright www.mioutlander.com
