Mitsubishi Outlander: If the display/indicator blinks while driving
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Auto Stop & Go (AS&G) system / If the display/indicator blinks while driving
If the
display/indicator blinks, the
Auto Stop & Go (AS&G) system is malfunctioning and will not operate.
We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
READ NEXT:
Manual transmission
The shift pattern is shown on the gearshift lever knob. During start-up, fully
depress the clutch pedal and shift into 1st gear or “R” (Reverse) position.
Then gradually release the clutch peda
Moving the gearshift lever to the “R” (Reverse) position
Vehicles equipped with 5M/T
To shift into the “R” (Reverse) position from 5th gear, move the gearshift lever
to the “N” (Neutral) position, and then move it to the “R” (Reverse) positio
Possible driving speed
Avoid shifting down at high speed, as this may cause excessive engine speed (the
tachometer needle into the red zone) and damage the engine.
Petrol-powered vehicles without MIVEC engine
Use 5 th
SEE MORE:
How to make or receive hands-free calls
You can make or receive hands-free calls using a Bluetooth® compatible cellular
phone connected to the Bluetooth® 2.0 interface.
You can also use the phone books in the Bluetooth ® 2.0 interface to make calls
without dialling telephone numbers.
Note
► The hands-free calls might not
Sunshade
Slide the sunshade manually to open and close it.
Caution
► Be careful that hands are not trapped when closing the sunshade.
Note
► Be sure to tilt down the sunroof before closing the sunshade.
► The sunshade cannot be closed with the sunroof opened.
© 2010-2026 Copyright www.mioutlander.com
