Mitsubishi Outlander: Information screen display list
When there is information to be announced, such as lamp reminders, a sound is
emitted and the screen switches to the displays shown below. Refer to the appropriate
page and take the necessary measures.
When the cause of the warning display is eliminated, the warning display goes
out automatically.
Refer to “Warning display list (when the ignition switch or the operation mode
is OFF)”.
Refer to “Warning display list (when the ignition switch or the operation mode
is ON)”.
Refer to “Other interrupt displays”.
NOTE
• A warning may be displayed on the information screen and the buzzer may sound in the following rare cases.
This is caused by the system picking up interference such as noise or strong electromagnetic waves, and is not a functional problem.
• An extremely strong electromagnetic wave is received from a source such as an illegal radio set, a spark from a wire, or a radar station.
• Abnormal voltage or a static electricity discharge is generated by the operation of installed electrical equipment (including after-market parts).
If the warning display appears many times, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
Warning display list (when the ignition switch or the operation mode is OFF)
Warning display list (when the ignition switch or the operation mode is ON)
Other interrupt displays
The operation status of each system is displayed on the information screen. Refer to the appropriate page for the system for further details.
This informs you that a periodic inspection is due.
The setting for rest interval can be changed.
READ NEXT:
Indication lamps
Turn-signal indication lamps/ Hazard warning indication lamps
These indication lamps blink in the following situations.
• When the turn-signal lever is moved to activate a turn-signal lamp.
•
Warning lamps
Brake warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position
or the operation mode is put in ON, and goes off after a few seconds.
Always make sure that t
Information screen display
Brake warning display
This warning is displayed if you drive with the parking brake still applied.
The warning lamp in the instrument cluster only illuminates when the parking brake
is applied.
SEE MORE:
Traffic information
The radio will automatically tune in to traffic information broadcasts while
receiving UKW broadcasts, playing cassettes.
To select this function, follow the instructions below.
1. Press the TP button (2). The display will show “TP” (11). If the RDS data
can be read, the display will show
Headlamps (low beam, except for vehicles with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the vehicle.
: Front of the vehicle
2. For petrol-powered vehicles equipped with turbocharger, when r
