Mitsubishi Outlander: Interior lamps
1- Cargo room lamp
2- Rear room lamp
3- Front room & map lamps
Note
► If you leave the interior lamps on without running the engine, you will run down the battery.
Before you leave the vehicle, make sure that all the interior lamps are off.
- Front room & map lamps
- Map lamps
- Rear room lamp
- Cargo room lamp
- Lamps (room lamps, etc.) auto-cutout function (Vehicles with keyless entry system or keyless operation system)
READ NEXT:
Front room & map lamps
1 (DOOR) - The lamp illuminates when a door or the rear hatch is opened. It goes
off about 15 seconds after the door or rear hatch is closed. However, the lamp goes
off immediately in the follow
Map lamps
Push the lens (A) to turn on the lamp. Push it again to turn it off.
Rear room lamp
The room lamp can be turned on by sliding the room lamp switch.
1 (ON) - The room lamp goes on.
2 ( ) - The lamp illuminates when a door or the rear hatch is opened. It goes
off about 15 seconds
SEE MORE:
Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
: Front of the vehicle
3. Turn the bulb (C) antic
Changing the language cooperative control
The language used in MITSUBISHI Multi-Communication System (MMCS) (if so equipped)
or the Bluetooth® 2.0 interface (if so equipped) can be changed automatically to
the same language as that shown in the multi-information display.
1. Press and hold the multi-information meter switch for about 2
© 2010-2025 Copyright www.mioutlander.com
