Mitsubishi Outlander: Front room & map lamps
1 (DOOR) - The lamp illuminates when a door or the rear hatch is opened. It goes off about 15 seconds after the door or rear hatch is closed. However, the lamp goes off immediately in the following cases: ► The ignition switch is turned to the “ON” position.
► All the doors and the rear hatch are locked using the central door lock function.
► If the vehicle is equipped with the keyless entry system, when the remote control switch of the keyless entry system is used to lock the vehicle.
► If the vehicle is equipped with the keyless operation system, when the remote control switch of the keyless operation system or the keyless operation function is used to lock the vehicle.
Note
► When the key was used to start the engine, if the key is removed while the doors and rear hatch are closed, the lamp is illuminated and after about 15 seconds it goes off.
► When the keyless operation function was used to start the engine, if the ignition switch is turned to the “LOCK” position while the doors and rear hatch are closed, the lamp illuminates and after about 15 seconds it goes off.
► The time until the lamp goes off can be adjusted.
For details, please consult a MITSUBISHI MOTORS Authorized Service Point.
If the vehicle is equipped with the MITSUBISHI Multi-Communication System (MMCS), adjustment can be made using screen operations. Refer to the separate owner’s manual for details.
2 (OFF) - The lamp goes off.
READ NEXT:
Map lamps
Push the lens (A) to turn on the lamp. Push it again to turn it off.
Rear room lamp
The room lamp can be turned on by sliding the room lamp switch.
1 (ON) - The room lamp goes on.
2 ( ) - The lamp illuminates when a door or the rear hatch is opened. It goes
off about 15 seconds
Cargo room lamp
1 (ON) - The lamp illuminates regardless of whether the rear hatch is open or
closed.
2 - The lamp illuminates when the rear hatch is opened, and goes off when the
rear hatch is closed.
3 (OFF
SEE MORE:
Changing the security alarm settings
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Turn the ignition switch to the “LOCK” position.
If you started the engine with the key, remove the key from the ignition switch.
2. Place the lamp switch in the “OFF”
Turn-signal indication lamps/ Hazard warning indication lamps
These indication lamps blink in the following situations.
► When the turn-signal lever is moved to activate a turn-signal lamp.
Refer to “Turn-signal lever”.
► When the hazard warning flasher switch is pressed to activate the hazard warning
lamps.
Refer to “Hazard warning f
