Mitsubishi Outlander: Introduction of outside air

To introduce air into the vehicle during hot weather, set the air selection switch
(A) to the outside position and set the temperature control dial to the position
shown in the illustration. Be sure to set the temperature control dial all the way
to the left. Select the desired blower speed.
NOTE
Turn the mode selection dial clockwise and air will flow to the leg area and
the windscreen.

READ NEXT:
Set the mode selection dial to the “”
position.
Set the air selection switch (A) to the outside position and push the air conditioning
switch (B).
Adjust the temperature by turning the tem
The air conditioning can only be operated while the engine is running.
CAUTION
When using the air conditioning, the idling speed may slightly increase
as the air conditioning compressor is switche
In normal conditions, use the system in the AUTO mode and follow these procedures:
1- Set the blower speed selection dial to “AUT” position.
2- Turn the temperature control dial to set the des
SEE MORE:
The label shown here is attached on vehicles with front passenger air bag. If
this label is attached, never install the rearfacing child restraint on the front
passenger’s seat.
WARNING
(1) Extreme Hazard ! REAR-FACING CHILD RESTRAINTS must NOT be used in
the front passenger seat as it
Children who have outgrown the child restraint system should be seated in the
rear seat and wear a combination lap shoulder belt.
The lap belt should be snug and positioned low on the abdomen so that it is below
the top of the hip-bone. Otherwise, the belt could intrude into the child’s abdom
© 2010-2026 Copyright www.mioutlander.com
