Mitsubishi Outlander: Jacking up 4-wheel drive vehicles
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Cautions on handling of 4-wheel drive vehicles / Jacking up 4-wheel drive vehicles
Warning
► Do not crank the engine while jacking up the vehicle.
The tyre on the ground may turn and the vehicle may roll off the jack.
READ NEXT:
ACD (Active centre differential system
The ACD is a system that improves acceleration performance and straight-ahead
stability by regulating the differential limiting action and power drive distribution
of the centre differential.
Ca
ACD control mode
Select the control mode from the following three types to suit the driving conditions.
ACD control mode switch
When the ignition switch is set to the “ON” position, operate the AWC switch
to change the control mode.
Each time the switch is pushed, the control mode changes in the order “TARMAC”
SEE MORE:
To remove
1. Wrap the tip of the bar with a cloth, insert it deeply into the notch provided
in the wheel cover, and use it to lever up the cover a little.
2. With the cover raised a little, pry it off completely using the jack bar.
Insert the jack bar under the cover, and move it around the circumferen
Tools and jack
Storage
The tools and jack are stowed on the right side of the luggage area.
The storage location of the tools and jack should be remembered in case of an
emergency.
1- Jack.
2- Tools.
Tools
1- Tool case.
2- Wheel nut wrench.
3- Jack bar.
4- Towing hook.
Jack
To remove
1. Turn th
© 2010-2026 Copyright www.mioutlander.com
