Mitsubishi Outlander manuals

Mitsubishi Outlander: Keyless operation key take-out monitoring system

Type 1

Type 2

Type 2

When the vehicle is parked with the ignition switch in any position other than

When the vehicle is parked with the ignition switch in any position other than “LOCK” (PUSH OFF), if you close the door after opening any of the doors and taking the keyless operation key out of the vehicle, a warning displays and the buzzer sounds 4 times.

► If you take the keyless operation key out of the vehicle through a window without Note

► If you take the keyless operation key out of the vehicle through a window without opening a door, the keyless operation key takeout monitoring system does not operate.

► It is possible to change the setting to make the keyless operation key take-out monitoring system operate if you take the keyless operation key out from the vehicle through a window without opening a door. For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.

► Even if you have the keyless operation key within the engine start operating range, if the keyless operation key and vehicle ID codes cannot be matched, for example due to the ambient environment or electromagnetic conditions, the warning may be activated.

READ NEXT:

 Key lock-in prevention system

When the ignition switch is in the “LOCK” (PUSH OFF) position, if you close all the doors and the rear hatch with the keyless operation key left in the vehicle and you try to lock the doors

 Door ajar prevention system

When the ignition switch is in the “LOCK” (PUSH OFF) position, if you try to lock the doors and rear hatch by pressing the driver’s or front passenger’s door lock/unlock switch, or the r

 Ignition switch turn-off reminder system

When the ignition switch is in any position other than the “LOCK” (PUSH OFF) position, if you close all the doors and the rear hatch then try to lock the doors and rear hatch by pressing the

SEE MORE:

 Average speed

For vehicles with MITSUBISHI genuine audio, average speed can be displayed. This value shows the average speed (in km/h or mph) since the display was reset. If you reset the display at the time when you want to start the measurements, average speed from that point of time can be displayed.

 Indication and warning lamp list

1- Position lamp indication lamp ® 2- High-beam indication lamp ® 3- Charge warning lamp ® 4- Turn-signal indication lamps/Hazard warning indication lamps ® 5- Front fog lamp indication lamp* ® 6- Rear fog lamp indication lamp ® 7- Anti-lock brake system (ABS) warning lamp ® 8- Brake

© 2010-2026 Copyright www.mioutlander.com