Mitsubishi Outlander: Manual air conditioning
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / For pleasant driving / Manual air conditioning
The air conditioning can only be used while the engine is running.
READ NEXT:
Control panel
A- Temperature control dial
B- Air selection switch
C- Blower speed selection dial
D- Air conditioning switch
E- Mode selection dial
F- Rear window demister switch
Blower speed selection dial
Operating the air conditioning system
Heating
Set the mode selection dial to the
position and set the air selection switch (A) to the outside position.
Turn the temperature control dial clockwise or anticlockwise to the desired temper
Automatic air conditioning
The air conditioning can only be used while the engine is running.
SEE MORE:
Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal. (M/T)
Note
► On vehicles with the Auto Stop & Go (AS&G) system, the starter will not operate
unless
Obstacle detection areas
The detection areas of the corner and back sensors are limited to those shown
in the illustration. Moreover, the sensors are unable to detect low or thin objects
or objects near the rear bumper. Thus, make sure to check the surroundings as you
operate the vehicle in a safe manner.
Corner and
© 2010-2026 Copyright www.mioutlander.com
