Mitsubishi Outlander: Manual type
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Seat and seat belts / Front seat / To recline the seatback / Manual type
In order to recline the seatback, lean forward slightly, pull the seatback lock lever up, and then lean backward to the desired position and release the lever.
The seatback will lock in that position.
Caution
► The reclining mechanism of the seatback is spring loaded, causing it to return to the vertical position when the lock lever is operated. When using the lever, sit close to the seatback or hold it with your hand to control its return motion.
READ NEXT:
Power type (driver’s side only)
Adjust the seatback angle by operating the switch as indicated by the arrows.
1- To move to forward direction
2- To recline rearward
Note
► To prevent the battery from running down, opera
Manual type
Operate the lever repeatedly to raise or lower the seat.
1- Raise
2- Lower
SEE MORE:
If your vehicle is stuck: in sand, mud or snow
If the vehicle becomes stuck in snow, sand, or mud, it can often be moved by
a rocking motion. Move the gearshift lever or selector lever alternately between
the 1st and Reverse position (with manual transmission), the “L” (LOW) and “R” (REVERSE)
position (with INVECS–II 4A/T), and t
Setting the system
1. Turn the ignition switch to the “LOCK” position.
Also, if a key was used to start the engine, remove the key from the ignition
switch.
2. Get out of the vehicle. Close all doors and rear hatch.
3. Press the LOCK switch (A) on the remote control switch, the driver’s or front
passenger
© 2010-2026 Copyright www.mioutlander.com
