Mitsubishi Outlander: Passenger compartment fuse location table
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Fuses / Fuse load capacity / Passenger compartment fuse location table
Note
► Spare fuses are provided on the lid of the fuse block in the engine compartment. Always use a fuse of the same capacity for replacement.
: Fusible link
► Some fuses may not be installed on your vehicle, depending on the vehicle model or specifications.
► The table above shows the main equipment corresponding to each fuse.
READ NEXT:
Engine compartment fuse location table
1: Except for petrol-powered vehicles equipped with turbocharger
2: Petrol-powered vehicles with turbocharger
3: Fusible link
1: Except for petrol-powered vehicles equipped with turbochar
Fuse replacement
1. Before replacing a fuse, always turn off the electrical circuit concerned
and place the ignition switch in the “LOCK” position.
2. Remove the fuse puller (A) from the inside of the fuse box
SEE MORE:
Changing the mode selection
To change the position and amount of air flowing from the ventilators, turn the
mode selection dial.
(Refer to “Mode selection dial”.) These symbols are used in the
next several illustrations to demonstrate the quantity of air coming from the ventilators.
: Small amount of air from the ven
Interior lamps
1- Luggage room lamp
2- Room lamp (rear)*
3- Map & room lamps (front) Sunshade illumination dimming control switch*
NOTE
• If you leave the lamps on without running the engine, you will run down the
battery.
Before you leave the vehicle, make sure that the lamps are turned off.
Map
© 2010-2025 Copyright www.mioutlander.com
