Mitsubishi Outlander: Rear window demister switch
The rear window demister switch can be operated with the ignition switch in the “ON” position.
Push the switch to turn on the rear window demister. To turn off the demister, push the switch again. As your vehicle is equipped with the rear window demister timer, it will be turned off automatically in about 20 minutes. To turn off the demister within 20 minutes, push the switch again.
The indication lamp (A) will illuminate while the demister is on. If your vehicle is equipped with a mirror heater, when the demister switch is pressed, the mist can also be removed from the outside rear-view mirrors. Refer to “Electric remote-controlled outside rear-view mirrors” on page 5–32.
CAUTION
(1) The demister switch is not to melt snow but to clear mist. Remove snow
before using the demister switch.
(2) To avoid unnecessary discharge of the battery,
do not use the rear window demister when the engine is not running. Turn the demister
off immediately after the window is clear.
(3) When cleaning the inside of the
rear window, use a soft cloth and wipe gently along the heater wires, being careful
not to damage the wires.
(4) Do not allow objects to touch the inside of the rear
window glass, damaged or broken wires may result.
READ NEXT:
Front fog lamp switch*
The front fog lamp can be operated when the headlamps or tail lamps turn on.
Push the switch to turn on the front fog lamps, and push the switch again to turn
them off.
The indication lamp in t
Rear fog lamp switch
The rear fog lamp can be operated when the headlamps or front fog lamps (if so
equipped) turn on.
Push the switch to turn on the gear fog lamp, and push the switch again to turn
it off. The ind
Rheostat (meter illumination control)
The rheostat can be adjusted while the lamp switch is “”
or “”. Turn the dial to adjust the meter
illumination to the desired brightness.
1- To increase brightness 2- To reduce brightne
SEE MORE:
Front turn-signal lamps
1. Remove the clips (A) and clips (B), then remove the duct (C) and the upper
cover (D).
2. Remove the entire socket and bulb assembly (E) by turning it anticlockwise.
: Front of the vehicle
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal steps in reve
Vehicle equipped with steel wheels
Tighten the wheel nuts (tapered nuts) until the tapered parts of the wheel nuts
make light contact with the seats of the wheel holes and the wheel is not loose.
With a spare wheel, tighten the wheel nuts in the same way.
Vehicle equipped with aluminium wheels
Tighten the wheel nuts (flange nu
