Mitsubishi Outlander manuals

Mitsubishi Outlander: Front turn-signal lamps

1. Remove the clips (A) and clips (B), then remove the duct (C) and the upper cover (D).

2. Remove the entire socket and bulb assembly (E) by turning it anticlockwise.

2. Remove the entire socket and bulb assembly (E) by turning it anticlockwise.

: Front of the vehicle

: Front of the vehicle

3. Remove the bulb by pulling it out.

4. To install the bulb, perform the removal steps in reverse.

4. To install the bulb, perform the removal steps in reverse.

READ NEXT:

 Front fog lamps (Type 1)

1. Remove the screw (A) and pull the cover out. 2. Remove the screws (B) and pull the entire lamp unit out. Note ► When unfastening the screws, be careful not to mistakenly move the beam

 Front fog lamps (Type 2)

1. Remove the screw (A). 2. Pull the cover out in the direction of the arrow shown in the illustration. 3. Remove the screws (B) and pull the entire lamp unit out. Note ► When unfaste

 Rear combination lamps

SEE MORE:

 Starting the engine (Diesel-powered vehicles)

1. Insert the ignition key and fasten the seat belt. 2. Apply the parking brake. 3. Depress and hold the brake pedal. 4. Place the gearshift lever in the “N” (Neutral) position. 5. Fully depress the clutch pedal. 6. Turn the ignition key to the “ON” position. The diesel preheat indic

 Electronic immobilizer (Anti-theft starting system)

The electronic immobilizer is designed to reduce significantly the possibility of vehicle theft. The purpose of the system is to immobilize the vehicule if an invalid start is attempted. A valid start attempt can only be achieved (subject to certain conditions), using a key “registered” to

© 2010-2026 Copyright www.mioutlander.com