Mitsubishi Outlander: Rear combination lamps
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Rear combination lamps
READ NEXT:
Stop and tail lamps and rear turn-signal lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a
cloth or other object at the edge of the cover and pry gently to remove the cover.
2. Remove the socket and bulb asse
Reversing lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a
cloth or other object into the cut out area of the cover and pry gently to remove
the cover.
2. Remove the socket a
Rear fog lamp
1. Remove the socket and bulb assembly by turning it anticlockwise.
2. Remove the bulb by pulling it out.
3. To install the bulb, perform the removal steps in reverse.
SEE MORE:
To find the start of a desired track
The start of each track on a disc can be found by using the
or
button (7 or 8).
Track up:
Press the button (8) the number
of tracks to skip over.
The frequency-display window will display the number of tracks thus selected.
Track down:
Press the button (7) the number
of tracks to skip
Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)
Do not attempt to disassemble or repair headlamps, and do not attempt to replace
their bulbs.
Warning
► A high voltage is present in the power circuit and in the bulbs and bulb
terminals.
To avoid the risk of an electric shock, contact a MITSUBISHI MOTORS Authorized Service
Point whe
© 2010-2026 Copyright www.mioutlander.com
