Mitsubishi Outlander: Reversing lamps
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Rear combination lamps / Reversing lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a cloth or other object into the cut out area of the cover and pry gently to remove the cover.
2. Remove the socket and bulb assembly by turning it anticlockwise.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal steps in reverse.
Note
► When installing the lid, align the tab on the lid with the hole on the vehicle side.
READ NEXT:
Rear fog lamp
1. Remove the socket and bulb assembly by turning it anticlockwise.
2. Remove the bulb by pulling it out.
3. To install the bulb, perform the removal steps in reverse.
Licence plate lamps
1. Remove while pressing the lamp unit (A) to the left side.
2. Insert a minus screwdriver with the end covered with a cloth or other object
to press the hook (B) aside and remove the lens.
3.
Front room & map lamps
When replacing the bulb, put the front room & map lamps switch into the “OFF”
position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the l
SEE MORE:
Reversing sensor system operation indication lamp
In case there is a malfunction in the reversing sensor system, the reversing
sensor system operation indication lamp will blink and the warning buzzer will sound
for approximately 5 seconds. Even after the buzzer has stopped sounding, the indication
lamp will continue flashing until the system
Selector lever operation
The CVT selects an optimum gear ratio automatically, depending on the speed of
the vehicle and the position of the accelerator pedal.
The selector lever (A) has 2 gates; the main gate (B) and the manual gate (C).
Warning
► Always depress the brake pedal when shifting the selector lev
© 2010-2026 Copyright www.mioutlander.com
