Mitsubishi Outlander manuals

Mitsubishi Outlander: Rear fog lamp

1. Remove the socket and bulb assembly by turning it anticlockwise.

2. Remove the bulb by pulling it out.

2. Remove the bulb by pulling it out.

3. To install the bulb, perform the removal steps in reverse.

3. To install the bulb, perform the removal steps in reverse.

READ NEXT:

 Licence plate lamps

1. Remove while pressing the lamp unit (A) to the left side. 2. Insert a minus screwdriver with the end covered with a cloth or other object to press the hook (B) aside and remove the lens. 3.

 Front room & map lamps

When replacing the bulb, put the front room & map lamps switch into the “OFF” position. 1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into the notch of the l

 Rear room lamp

When replacing the bulb, put the rear room lamp switch into the “OFF” position. 1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into the notch of the lamp assembly a

SEE MORE:

 Automatic headlamp levelling

This mechanism automatically adjusts the direction of the headlamps (beam position) depending on changes in the condition of the vehicle, such as the number of occupants or luggage weight. When the headlamps are illuminated with the ignition switch in the “ON” position, the beam position o

 Fluid type

Use brake fluid conforming to DOT3 or DOT4 from a sealed container. The brake fluid is hygroscopic. Too much moisture in the brake fluid will adversely affect the brake system and clutch system, reducing the performance. Caution ► Take care in handling brake fluid as it is harmful to t

© 2010-2026 Copyright www.mioutlander.com