Mitsubishi Outlander: Licence plate lamps
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Licence plate lamps
1. Remove while pressing the lamp unit (A) to the left side.
2. Insert a minus screwdriver with the end covered with a cloth or other object to press the hook (B) aside and remove the lens.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal steps in reverse.
Note
► When installing the lamp, insert tab (C) first then align and insert tab (D).
READ NEXT:
Front room & map lamps
When replacing the bulb, put the front room & map lamps switch into the “OFF”
position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the l
Rear room lamp
When replacing the bulb, put the rear room lamp switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the lamp assembly a
Cargo room lamp
When replacing the bulb, put the cargo room lamp switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the lamp assembly
SEE MORE:
General maintenance
Fuel, engine coolant, oil and exhaust gas leakage
Look under the body of your vehicle to check for fuel, engine coolant, oil and
exhaust gas leaks.
WARNING
• If you see a suspicious fuel leak or if you smell fuel, do not operate the
vehicle; call your MITSUBISHI MOTORS Authorized Service P
Removal of head restraints
To remove the head restraints, lift the head restraint with the height adjusting
knob (A) pushed in.
To install the head restraints, first confirm that they are facing in the correct
direction, and then insert them into the seatback while pressing the height adjusting
knobs (A) in the direc
© 2010-2026 Copyright www.mioutlander.com
