Mitsubishi Outlander: Front room & map lamps
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Front room & map lamps
When replacing the bulb, put the front room & map lamps switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into the notch of the lamp assembly. Gently pry to remove the lens.
2. While holding down the tab (A), pull out the bulb.
3. To install the bulb, perform the removal steps in reverse.
Note
► When mounting the lens, align the tab (B) to the hole on the vehicle body.
READ NEXT:
Rear room lamp
When replacing the bulb, put the rear room lamp switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the lamp assembly a
Cargo room lamp
When replacing the bulb, put the cargo room lamp switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the lamp assembly
SEE MORE:
Four-Cylinder Power (Or Lack Thereof)
As mentioned, the Outlander's base powertrain is a letdown. The
168-horsepower, 2.4-liter four-cylinder teams with a continuously variable
automatic transmission, and the results are uninspiring, to say the least.
The biggest problem with the drivetrain is that acceleration isn't as
immediat
Manual mode
The manual adjustment mode is also available in case the “Auto mode” shows the
incorrect time when the adjacent local RDS stations are located in a different time
zone.
For manual time adjustment, use the procedure below:
1. Switch off the audio once by pressing the PWR switch (1). 2. Whil
© 2010-2026 Copyright www.mioutlander.com
