Mitsubishi Outlander: Front fog lamps (Type 2)
1. Remove the screw (A).
2. Pull the cover out in the direction of the arrow shown in the illustration.
3. Remove the screws (B) and pull the entire lamp unit out.
Note
► When unfastening the screws, be careful not to mistakenly move the beam position adjustment screw (C).
4. Push the connector (D) to disconnect and remove the fog lamp.
5. Remove the bulb assembly (E) by turning it anticlockwise.
Caution
► Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is highly pressurized, so dropping, knocking,
or scratching a halogen lamp bulb can cause it to shatter.
► Never hold the halogen lamp bulb with a bare hand, dirty glove, etc.
The oil from your hand could cause the bulb to break the next time the fog lamps
are operated.
If the glass surface is dirty, it must be cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
6. To install the bulb, perform the removal steps in reverse.
Note
► When mounting the cover, align the hook (F) on the cover with the hole in the body.
READ NEXT:
Stop and tail lamps and rear turn-signal lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a
cloth or other object at the edge of the cover and pry gently to remove the cover.
2. Remove the socket and bulb asse
Reversing lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a
cloth or other object into the cut out area of the cover and pry gently to remove
the cover.
2. Remove the socket a
SEE MORE:
How to change a tyre
Before changing a tyre, first stop your vehicle in a safe, flat location.
1. Park the vehicle on level and stable ground, free of loose pebbles, etc.
2. Set the parking brake firmly.
3. On vehicles with M/T, stop the engine and move the gearshift lever to the
“R” (Reverse) position.
On veh
Steering control switch
1- Volume up button
2- Volume down button
3- SPEECH button
4- PICK-UP button
5- HANG-UP button
Volume up button
Press this button to increase the volume.
Volume down button
Press this button to decrease the volume.
SPEECH button
• Press this button to change to voice recognition mode.
