Mitsubishi Outlander: Rear window wiper and washer
The rear window wiper and washer switch can be operated with the ignition switch in the “ON” or “ACC” position.
INT- The wiper operates continuously for several seconds then operates intermittently at intervals of about every 8 seconds
OFF- Off
The washer fluid will be sprayed onto the rear window when the knob is turned fully in either direction.
The wipers operate automatically several times while the washer fluid is being sprayed.
Note
► The rear window wiper will automatically perform several continuous operations
if the gearshift lever or the selector lever is put in the “R” position while the
windscreen wipers or the rear window wiper is operating. (automatic operation mode)
After the automatic operation, the rear window wiper will stop operating if the
knob is in the “OFF” position. If the knob is in the “INT” position, the rear window
wiper will return to the intermittent operation.
It is possible to set the rear window wiper to perform the automatic operation only
if the gearshift lever or the selector lever is put in the “R” position while the
rear window wiper is operating with the knob in the “INT” position.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
► If the knob is in the “OFF” position, turn the knob to the “INT” position twice
quickly to operate the rear window wiper continuously.
(continuous operation mode)
Turn the knob to the “OFF” position to stop the rear window wiper continuous operation.
► The interval for intermittent operation can be adjusted.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
READ NEXT:
Headlamp washer switch
The headlamp washer can be operated when the ignition switch is in the “ON” or
“ACC” position and the headlamps are on.
Push the button once and the washer fluid will be sprayed on to the h
Rear window demister switch
The rear window demister switch can be operated when the engine is running.
Push the switch to turn on the rear window demister.
It will be turned off automatically in about 20 minutes. To turn off
Horn switch
Press the steering wheel on or around the
mark.
SEE MORE:
Changing the security alarm settings
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Except for vehicles equipped with the keyless operation system, remove the
key from the ignition switch. For vehicles equipped with the keyless operation system,
put the ope
Heated seats
The heated seats can be operated with the ignition switch in the “ON” position.
Operate the switch as indicated by arrows.
The indication lamp (A) will illuminate while the heater is on.
1 (HI)- Heater high (for quick heating).
2- Heater off.
3 (LO)- Heater low (to keep the seat warm).
