Mitsubishi Outlander: Retracting and extending the mirrors without using the mirror retractor switch
[Vehicles with keyless entry system] The mirrors automatically retract or extend when the doors are locked or unlocked using the remote control switches of the keyless entry system. Refer to “Keyless entry system”.
[Vehicles with keyless operation system] The mirrors automatically retract or extend when the doors are locked or unlocked using the remote control switches or the keyless operation function of the keyless operation system. Refer to “Keyless operation system: To operate using the keyless operation function, Keyless entry system” on pages 1-09 and 1-04.
Note
► Functions can be modified as stated below.
Consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations
can be used to make the adjustment.
Refer to the separate owner’s manual for details.
• Automatically extend when the ignition switch is turned to the “ON” position,
and automatically retract when the driver’s door is opened after the ignition switch
is turned to the “OFF” position.
• Automatically extend when the vehicle speed reaches 30 km/h (19 mph).
• Deactivate the automatic extension function.
READ NEXT:
Heated mirror
To demist or defrost the outside rear-view mirrors, press the rear window demister
switch.
The indication lamp (A) will illuminate while the demister is on.
The heater will be turned off automatic
Ignition switch
[For vehicles equipped with keyless operation system]
For information on operations for vehicles equipped with the keyless operation
system, refer to “Keyless operation system: Ignition switch”
ACC power auto-cutout function
After about 30 minutes has elapsed with the ignition switch in the “ACC” position,
the function automatically cuts out the power for the audio system and other electric
devices that can be ope
SEE MORE:
Exterior and interior lamp operation
Operate the combination lamp switch to check that all lamps are functioning properly.
If the lamps do not illuminate, the probable cause is a blown fuse or defective
lamp bulb. Check the fuses first. If there is no blown fuse, check the lamp bulbs.
For information regarding the inspection and r
ACD control mode display
Example: “TARMAC” mode is selected.
The currently selected control mode is displayed on the multi-information display.
In addition, when the control mode is changed, the selected mode appears on the
interrupt display screen of the information screen in the multi-information display.
The c
