Mitsubishi Outlander manuals

Mitsubishi Outlander: Steering wheel lock

[For vehicles equipped with the keyless operation system].

For information on operations for vehicles equipped with the keyless operation system, refer to “Keyless operation system:

Steering wheel lock”.

[Except for vehicles equipped with the keyless operation system].

To lock

Remove the key at the “LOCK” position.

Turn the steering wheel until it is locked.

To unlock

Turn the key to the “ACC” position while moving the steering wheel slightly.

CAUTION:

CAUTION:

● Remove the key when leaving the vehicle.

In some countries, it is prohibited to leave the key on the vehicle when parked.

READ NEXT:

 Starting the engine

[For vehicles equipped with the keyless operation system]. For information on operations for vehicles equipped with the keyless operation system, refer to “Keyless operation system: Starting”,

 Manual transmission

The shift pattern is shown on the gearshift lever knob. Be sure to always fully depress the clutch pedal before attempting to shift the lever. CAUTION: ● Do not put the gearshift lever int

 Electronically controlled 4WD system

The electronically controlled 4WD system is an 4-wheel drive system that allows one of three drive modes to be selected with a switch, in accordance with the driving conditions. The following dri

SEE MORE:

 Transaxle Control

REMOVAL AND INSTALLATION WARNING When removing and installing the transaxle control cable and shift lock cable unit, be careful not to hit the SRS-ECU. Pre-removal operation Front floor console assembly removal Post-installation operation Front floor console assembly installation Key interloc

 Crankshaft and Cylinder Block

REMOVAL AND INSTALLATION Removal steps Crankshaft bearing cap bolt Crankshaft bearing cap Crankshaft bearing lower Crankshaft Crankshaft bearing upper Thrust bearing Crankshaft sensing ring Cylinder block REMOVAL SERVICE POINT CRANKSHAFT REMOVAL When temporarily placing the crankshaft wit

© 2010-2021 Copyright www.mioutlander.com