Mitsubishi Outlander: To fasten
1. Pull the seat belt out slowly while holding the latch plate.
Note
► When the seat belts cannot be pulled out in a locked condition, pull the belts once forcefully and then return them. After that, pull the belts out slowly once again.
2. Insert the latch plate into the buckle until a “click” is heard.
Warning
► Never wear the lap portion of the belt across your abdomen. During accidents
it can press sharply against the abdomen and increase the risk of injury.
► The seat belts must not be twisted when worn.
3. Pull the belt slightly to adjust slackness as desired.
READ NEXT:
To unfasten
Hold the latch plate and push the button on the buckle.
Note
► As the belt retracts automatically, keep holding the latch plate while retracting
so that the belt stows slowly. Failure to
Driver’s seat belt reminder/warning lamp and display
Warning lamp
A tone and warning lamp are used to remind the driver to fasten the seat belt.
If the ignition switch is set to the “ON” position without the driver’s seat
belt being fasten
Front passenger seat belt warning lamp
The front passenger seat belt warning lamp is located on the instrument panel.
The lamp comes on when a person sits on the front passenger seat but does not
fasten the seat belt. It goes off when
SEE MORE:
Moving the gearshift lever to the “R” (Reverse) position
Vehicles equipped with 5M/T
To shift into the “R” (Reverse) position from 5th gear, move the gearshift lever
to the “N” (Neutral) position, and then move it to the “R” (Reverse) position.
Vehicles equipped with 6M/T
Pull up the pull-ring (A), then move the gearshift lever to the “
Luggage hooks
There are 4 hooks located on the side walls of the luggage compartment.
Use the hooks on the floor for securing the luggage.
CAUTION
• Do not pile up the luggage beyond the seatback height. Also, firmly secure
the luggage.
Otherwise, serious accidents could result due to hindered rearward
© 2010-2026 Copyright www.mioutlander.com
