Mitsubishi Outlander: Driver’s seat belt reminder/warning lamp and display
Warning lamp
A tone and warning lamp are used to remind the driver to fasten the seat belt.
If the ignition switch is set to the “ON” position without the driver’s seat belt being fastened, a warning lamp will blink and a buzzer will sound for approximately 6 seconds to remind you to fasten your seat belt.
If you then drive with the seat belt unfastened for longer than a minute from when the ignition switch was turned on, the warning lamp will come on and blink repeatedly and the tone will sound intermittently.
The warning lamp and the tone alarm will stop after approximately 90 seconds.
If you then repeatedly stop and start your vehicle with the seat belt unfastened, the warning lamp/display and tone will remind you to fasten your seat belt every time the vehicle starts moving. You will also be reminded to fasten your seat belt in this way when you remove your seat belt while driving.
The warning lamp and the tone alarm go off when the seat belt is fastened.
Note
► At the same time, “FASTEN SEAT BELT” is displayed on the information screen in the multi-information display.
READ NEXT:
Front passenger seat belt warning lamp
The front passenger seat belt warning lamp is located on the instrument panel.
The lamp comes on when a person sits on the front passenger seat but does not
fasten the seat belt. It goes off when
Adjustable seat belt anchor (front seats)
The seat belt anchor height can be adjusted.
Move the seat belt anchor down with the lock knob (A) depressed. To move the
anchor up, slide it without depressing the lock knob (A).
Warning
`
Pregnant women restraint
Warning
► Seat belts work for everyone, including pregnant women. Pregnant women should
use the available seat belts. This will reduce the likelihood of injury to both
the woman and the un
SEE MORE:
To fasten
1. Pull the seat belt out slowly while holding the latch plate.
Note
► When the seat belts cannot be pulled out in a locked condition, pull the belts
once forcefully and then return them. After that, pull the belts out slowly once
again.
2. Insert the latch plate into the buckle until
Second seat
When a person is sitting in the second seat, raise the head restraints to height
at which it lock in position. Refer to “Head restraints”.
NOTE:
● It is possible to adjust each side of the second seats forward and backward
independently of the other side, and to adjust the seatback a
