Mitsubishi Outlander: To operate
1. Stop the vehicle completely using the brake pedal.
2. Release the brake pedal and the hill start assist will maintain the braking force
applied while stopping for approximately 2 seconds.
3. Depress the accelerator pedal and the hill start assist gradually will decrease
the braking force as the vehicle starts moving.
Note
► The hill start assist is activated when all of the following conditions are
met.
• The engine is running.
(The hill start assist will not be activated while the engine is starting or immediately
after the engine is started.)
• The gearshift lever is in any position other than “P” (PARK) or “N” (NEUTRAL).
• The vehicle is completely stationary, with the brake pedal depressed.
• The parking brake is released.
► The hill start assist will not operate if the accelerator pedal is depressed before
the brake pedal is released.
► The hill start assist also operates when reversing on an uphill slope.
READ NEXT:
Warning display
If an abnormal condition occurs in the system, the following display/indicator
will turn on.
- ASC indicator
Warning display
Caution
► If the warning is displayed, the hill start assist
Emergency stop signal system
This is a device that reduces the possibility of rear end collisions by the rapid
and automatic blinking of the hazard warning lamps to alert vehicles approaching
from behind during sudden braking
Brake assist system
The brake assist system is a device assisting drivers who cannot depress the
brake pedal firmly when it is necessary to do so (such as in emergency stop situations)
and provides greater braking fo
SEE MORE:
Ventilators
1- Centre ventilators 2- Side ventilators
Air flow and direction adjustments
3- Ventilator dial 4- Knob
– Open
– Close
Set the ventilator dial (3) to the open position. Air always flows out from the
ventilator when the blower is switched on.
Adjust the direction of the air flow b
Position lamps (except for vehicles equipped with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the vehicle.
: Front of the vehicle
2. For petrol-powered vehicles equipped with turbocharger, when r
