Mitsubishi Outlander: Turn-signal lever
1- Turn-signals
When making a normal turn, use position (1). The lever will return automatically
when cornering is completed.
2- Lane-change signals
When moving the lever to (2) slightly to change a lane, the turn-signal lamps and
indication lamp in the instrument cluster will only flash while the lever is operated.
Also, when you move the lever to (2) slightly then release it, the turn-signal lamps
and indication lamp in the instrument cluster will flash 3 times.
Note
► If the lamp flashes unusually quickly, the bulb in a turn-signal lamp may have
burned out. We recommend you to have the vehicle inspected.
► It is possible to activate the following functions.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
• Flashing of the turn-signal lamps when the lever is operated with the ignition
switch in the “ACC” position.
• Deactivate the turn-signal lamp 3-flash function for lane changes
• The time required to operate the lever for the 3-flash function can be adjusted.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
READ NEXT:
Adaptive Front lighting System (AFS)
The AFS makes it easier for the driver to see ahead at night. While the lamp
switch is in the or “AUTO” position
(with the headlamps on), turning the steering wheel causes a bending lamp to a
Hazard warning flasher switch
Use the hazard warning flasher switch when the vehicle has to be parked on the
road for any emergency.
The hazard warning flashers can always be operated, regardless of the position
of the igniti
SEE MORE:
How to connect a USB memory device
1. Park your vehicle in a safe place and turn the ignition switch to the “LOCK”
position.
2. Open the USB input terminal cover (A) in the glove box.
3. Connect a commercially available USB connector cable (C) to the USB memory
device (B).
4. Connect the connector cable (C) to the USB
To remove the spare tyre
1. Lift up the board.
2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise.
Note
► Put the spare wheel under the vehicle body near the jack. This makes it safer
if the jack slips out of position.
