Mitsubishi Outlander: Tyres and wheels
Since the driving torque can be applied to the 4 wheels, the driving performance of the vehicle when operating in 4-wheel drive is greatly affected by the condition of the tyres.
Pay close attention to the tyres.
► Install only the specified tyres on all wheels.
Refer to “Tyres and wheels”.
► Be sure all 4 tyres and wheels are the same size and type.
When it is necessary to replace any of the tyres or wheels, replace all 4 tyres.
► All tyres should be rotated before the wear difference between the front and rear tyres is recognizable.
Good vehicle performance cannot be expected if there is a difference in wear between tyres. Refer to “Tyre rotation”.
► Check the tyre inflation pressure regularly.
Caution
► Always use tyres of the same size, same type, and same brand, and which have no wear differences. Using tyres of different size, type, brands or degree of wear, will increase the differential oil temperature, resulting in possible damage to the driving system. Further, the drive train will be subjected to excessive loading, possibly leading to oil leakage, component seizure, or other serious faults.
READ NEXT:
Towing
Caution
► Do not tow full-time 4WD vehicles with the front or rear wheels on the ground
(Type A or Type B) as illustrated. This could result in damage to the vehicle’s
driving system o
Jacking up 4-wheel drive vehicles
Warning
► Do not crank the engine while jacking up the vehicle.
The tyre on the ground may turn and the vehicle may roll off the jack.
ACD (Active centre differential system
The ACD is a system that improves acceleration performance and straight-ahead
stability by regulating the differential limiting action and power drive distribution
of the centre differential.
Ca
SEE MORE:
Information screen (when the ignition switch is “ON”)
Each time you lightly press the multi-information meter switch, the display screen
switches in the following order.
1- Odometer (Type 1)/Tripmeter
2- Odometer (Type 1)/Tripmeter
3- Service reminder
4- Engine coolant temperature display (Type 1)
5- Driving range display (Type 1)
6- Averag
Changing the function settings (when the ignition switch is “ON”)
1. Stop the vehicle in a safe place.
Firmly apply the parking brake and put the gearshift lever into the “N” (Neutral)
position (M/T), the selector lever into the “P” (PARK) position (CVT) or the gearshift
lever into the “P” (PARK) position (Twin Clutch SST).
2. Lightly press the m
