Mitsubishi Outlander: Antenna
To remove
Turn the pole (A) anticlockwise.
To install
Screw the pole (A) clockwise into the base (B) until it is securely retained.
Note
► Be sure to remove the roof antenna in the following cases:
• When using an automatic car wash.
• When placing a car cover over the vehicle.
• When driving into a structure that has a low ceiling.
READ NEXT:
Digital clock
Automatic mode and manual mode are available for digital clock adjustment.
Select the automatic mode or the manual mode by performing the following operations:
1. Press the PWR switch (A) to turn
Automatic mode
The automatic adjustment mode can set the local time automatically by using the
signal from local RDS stations. In this mode, CT (A) is shown in the display. Refer
to “Radio data system (RDS)”
Manual mode
The manual mode is also available in case the automatic mode shows the incorrect
time when the adjacent local RDS stations are located in a different time zone.
Refer to “Radio data system (RDS)
SEE MORE:
Caution for installing the child restraint on vehicle with front passenger air
bag
The label shown here is attached on vehicles with front passenger air bag. If
this label is attached, never install the rearfacing child restraint on the front
passenger’s seat.
WARNING
(1) Extreme Hazard ! REAR-FACING CHILD RESTRAINTS must NOT be used in
the front passenger seat as it
To install
Align the tyre valve with the valve opening provided on the wheel cover.
Then tap around the outer edge of the wheel cover with your hand to secure it
in place.
NOTE
Full wheel covers have a symbol mark provided on the reverse side to show
the air valve location.
Before installing the whee
© 2010-2026 Copyright www.mioutlander.com
