Mitsubishi Outlander: To install
Mitsubishi Carisma / Mitsubishi Carisma Owner's Manual / For emergencies / Wheel covers / To install
Align the tyre valve with the valve opening provided on the wheel cover.
Then tap around the outer edge of the wheel cover with your hand to secure it in place.
NOTE
Full wheel covers have a symbol mark provided on the reverse side to show the air valve location.
Before installing the wheel cover to the wheel, make sure that the opening with the symbol mark is correctly aligned with the air valve.
READ NEXT:
If a tyre is punctured
If a tyre must be changed due to a puncture, do so only after first following
every precaution for safety: parking the vehicle in a place where it is not a traffic
hazard or dangerous to you and y
Towing
Your vehicle may be towed either by another vehicle with a rope, or by a tow
truck.
The regulations concerning towing may differ from country to country. It is recommended
that you obey the regul
Towing with a rope
1. For vehicles with automatic transmission check the automatic transmission
fluid level. (Refer to “Automatic transmission fluid” on page 9–4.) If the fluid
level is low, transport the ve
SEE MORE:
Accessory socket
The accessory socket can be used while the ignition switch is in the “ON” or
“ACC” position.
Caution
► Be aware that using electronic equipment with the engine off may run the
battery down.
► When you connect an electrical device, make sure it is rated at 12 V and its ele
Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)
Do not attempt to disassemble or repair headlamps, and do not attempt to replace
their bulbs.
Warning
► A high voltage is present in the power circuit and in the bulbs and bulb
terminals.
To avoid the risk of an electric shock, contact a MITSUBISHI MOTORS Authorized Service
Point whe
© 2010-2026 Copyright www.mioutlander.com
