Mitsubishi Outlander: Changing the display language
The language of the multi-information display can be switched.
1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select “LANGUAGE” (language setting).
3. Press and hold the multi-information meter switch for about 2 seconds or more
to display “LANGUAGE” (language setting).
4. Lightly press the multi-information meter switch to select the desired language.
5. If you hold down the multi-information meter switch for about 2 seconds or more,
the setting is changed to the selected language.
Note
► The memory of the language setting is erased if the battery is disconnected,
and it returns automatically to ENGLISH or RUSSIAN.
► If “---” is selected in the language setting, a warning message is not displayed
when there is a warning display or interrupt display.
READ NEXT:
Changing the language cooperative control
The language used in MITSUBISHI Multi-Communication System (MMCS) (if so equipped)
or the Bluetooth® 2.0 interface (if so equipped) can be changed automatically to
the same language as that shown
Operation sound setting
You can turn off the operation sounds of the multiinformation meter switch and
daytime dipper button.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch fr
Changing the time until “REST REMINDER” is displayed
The time until the display appears can be changed.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer
SEE MORE:
To unfasten
Hold the latch plate and push the button on the buckle.
Note
► As the belt retracts automatically, keep holding the latch plate while retracting
so that the belt stows slowly. Failure to do this could damage the vehicle.
Replacement of lamp bulbs
Before replacing a bulb, ensure the lamp is off. Do not touch the glass part
of the new bulb with your bare fingers; the skin oil left on the glass will evaporate
when the bulb gets hot and the vapour will condense on the reflector and dim the
surface.
Caution
► Bulbs are extremely ho
